HONDA 2004 S2000 - Owner's Manual - Manual (Page 45)

The left or right turn signal indicator
blinks when you signal a lane change
or turn. If the indicators do not blink
or blink rapidly, it usually means one
of the turn signal bulbs is burned out
(see page
). Replace the bulb as
soon as possible, since other drivers
cannot see that you are signaling.
When you turn on the Hazard
Warning switch, both turn signal
indicators blink. All turn signals on
the outside of the vehicle should
flash.
This indicator comes on with the
high beam headlights. See page
for information on the headlight
controls.
This indicator comes on when you
turn the ignition switch to ON (II)
with the headlight switch off and the
parking brake set. It should go off if
you turn on the headlights or release
the parking brake. If it comes on at
any other time, it means there is a
problem with the DRL. There may
also be a problem with the high
beam headlights.
This indicator comes on for a few
seconds when you turn the ignition
switch to ON (II). It will go off if you
have inserted a properly-coded
ignition key. If it is not a properly-
coded key, the indicator will blink
and the engine will not start (see
page
).
This indicator also blinks several
times when you turn the ignition
switch from ON (II) to ACCESSORY
(I) or LOCK (0).
This indicator comes on when you
set the cruise control. See page
for information on operating the
cruise control.
This indicator comes on as a
reminder that you must refuel soon.
139
48
52
95
Canadian models only
Instrument Panel Indicators
Instruments and Controls
Turn Signal and
Hazard Warning
Indicators
High Beam Indicator
‘‘Daytime Running
Lights’’ Indicator
Immobilizer System
Indicator
Cruise Control Indicator
Low Fuel Indicator
42
Main Menu Table of Contents