Instrument panel indicators – HONDA 2005 CR-V - Owner's Manual User Manual
Page 62
This indicator comes on with the
high beam headlights. For more
information, see page
.
On Canadian models, this indicator
comes on with reduced brightness
when the daytime running lights
(DRL) are on (see page
).
This indicator comes on when you
turn the ignition switch to the ON
(II) position with the headlight
switch off and the parking brake set.
It should go off if you turn on the
headlights or release the parking
brake. If it comes on at any other
time, it means there is a problem
with the DRL. There may also be a
problem with the high beam
headlights.
This indicator comes on as a
reminder that you must refuel soon.
The left or right turn signal indicator
blinks when you signal a lane change
or turn. If an indicator does not blink
or blinks rapidly, it usually means
one of the turn signal bulbs is
burned out (see page
). Replace
the bulb as soon as possible, since
other drivers cannot see that you are
signaling.
When you press the hazard warning
button, both turn signal indicators
and all turn signals on the outside of
the vehicle flash.
When the indicator comes on, there
is about 2.74 US gal (10.4 ) of fuel
remaining in the tank before the
needle reaches E. There is a small
reserve of fuel remaining in the tank
when the needle does reach E.
This indicator comes on if the
tailgate or the hatch glass is not
closed tightly.
This indicator comes on if any door
is not closed tightly.
Canadian models only
Turn Signal and Hazard Warning
Indicators
High Beam Indicator
Low Fuel Indicator
Daytime Running Lights
Indicator
Tailgate and Hatch Glass
Open Indicator
Door-open Indicator
Instrument Panel Indicators
Inst
ru
m
e
nt
s
a
nd
Cont
ro
ls
59
Main Menu
Table of Contents