Instrument panel indicators – HONDA 2006 Element - Owner's Manual User Manual
Page 58
This indicator comes on when you
turn the ignition switch to the ON
(II) position with the headlight
switch off and the parking brake set.
It should go off if you turn on the
headlights or release the parking
brake. If it comes on at any other
time, it means there is a problem
with the DRL. There may also be a
problem with the high beam
headlights.
This indicator comes on with the
high beam headlights. For more
information, see page
.
This indicator comes on as a
reminder that you must refuel soon.
The left or right turn signal indicator
blinks when you signal a lane change
or turn. If the indicators do not blink
or they blink rapidly, it usually
means one of the turn signal bulbs is
burned out (see page
). Replace
the bulb as soon as possible, since
other drivers cannot see that you are
signaling.
When you turn on the hazard
warning button, both turn signal
indicators blink. All turn signals on
the outside of the vehicle should
flash.
On Canadian models, this indicator
comes on with reduced brightness
when the daytime running lights
(DRL) are on (see page
).
When the indicator comes on, there
is about 1.6 U.S. gal (6 ) of fuel
remaining in the tank before the
needle reaches E. There is a small
reserve of fuel remaining in the tank
when the needle does reach E.
This indicator comes on when you
set the cruise control. See page
for information on operating the
cruise control.
Canadian models only
If equipped
Turn Signal and Hazard Warning
Indicators
‘‘Daytime Running
Lights’’ Indicator
High Beam Indicator
Low Fuel Indicator
Cruise Control Indicator
Instrument Panel Indicators
56
Main Menu
Table of Contents