beautypg.com

Homelink universal transceiver – HONDA 2006 Ridgeline - Owner's Manual User Manual

Page 174

background image

For security purposes, newer garage
door opening systems use a ‘‘rolling’’
or variable code. Information from
the remote control and the garage
door opener are needed before
HomeLink can operate the garage
door opener.

Find the ‘‘training’’ button on your
garage door opener unit. The
location will vary, depending on
the manufacturer.

Make sure you have properly
completed the ‘‘Training
HomeLink’’ procedure.

Press the HomeLink button again.
It should operate the garage door.

The ‘‘Training HomeLink’’
procedure trains HomeLink to the
proper garage door opener code.
The following procedure
synchronizes HomeLink to the
garage door opener so it sends and
receives the correct codes.

Press the training button on the
garage door opener unit until the
indicator next to the button comes
on. The indicator may blink, or
come on and stay on. You then
have approximately 30 seconds to
complete the following steps.

Press and hold the button on
HomeLink for 3 to 4 seconds.

Press and hold the HomeLink
button again for 3 to 4 seconds.
This should turn off the training
indicator on the garage door
opener unit. (Some systems may
require you to press the button up
to three times.)

6.

2.

4.

5.

1.

3.

Training With a Rolling Code
System

HomeLink Universal Transceiver

Fe
a

tu

re

s

171

TRAINING BUTTON

Main Menu

Table of Contents