HONDA 2007 Civic Sedan - Owner's Manual - Manual (Page 250)

Your tires have wear indicators
molded into the tread. When the
tread wears down, you will see a
band 1/2 inch (12.7 mm) wide band
across the tread. This shows there is
less than 1/16 inch (1.6 mm) of tread
left on the tire.
A tire this worn gives very little
traction on wet roads. You should
replace the tire if you can see three
or more tread wear indicators.
Bumps or bulges in the tread or
side of the tire. Replace the tire if
you find either of these conditions.
Cuts, splits, or cracks in the side
of the tire. Replace the tire if you
can see fabric or cord.
Excessive tread wear.
Every time you check inflation, you
should also examine the tires for
damage, foreign objects, and wear.
You should look for:
The compact spare tire pressure is:
For convenience, the recommended
tire sizes and cold tire pressures are
on a label on the driver’s doorjamb.
For additional information about
your tires, see page
.
Optional for U.S. Si
284
Tire Size Cold Tire Pressure
Tires
Tire Inspection
Ma
int
e
na
nce
247
TREAD WEAR INDICATOR
INDICATOR LOCATION MARKS
60 psi (420 kPa , 4.2 kgf/cm )
32 psi (220 kPa ,
2.2 kgf/cm )
215/45R17 91W
competitive event at sustained high
speeds (over 118 mph or 190 km/h),
be sure to adjust the cold tire
pressures as shown in the following
We strongly recommend that you
do not drive faster than the posted
speed limits and conditions allow. If
you ever drive in a sanctioned
Si model only
High Speed Driving
Tire Size Cold Tire Pressure
Front: 35 psi (240 kPa ,
2.4 kgf/cm )
P205/55R16 89H
Rear: 32 psi (220 kPa ,
2.2 kgf/cm )
Si model only
chart. If you do not, excessive heat
can build up and cause sudden tire
failure.
Main Menu Table of Contents