HONDA 2008 Accord Coupe - Owner's Manual - Manual (Page 141)

The band and frequency that the
radio was last tuned to are displayed.
To change bands, press the AM or
FM button. On the FM band, ST will
be displayed if the station is
broadcasting in stereo. Stereo
reproduction in AM is not available.
On the AM band, AM noise
reduction turns on automatically.
The ignition switch must be in the
ACCESSORY (I) or ON (II) position.
Turn the system on by pushing the
power/volume knob or the AM or
FM button. Adjust the volume by
turning the power/volume knob. You can use any of five methods to
find radio stations on the selected
band: tune, skip, scan, the preset
buttons, and auto select.
The skip function searches
up and down from the current
frequency to find a station with a
strong signal. To activate it, press
and hold the
or side of the
SKIP bar until you hear a beep, then
release it.
On the FM band, you can also use
the features provided by the radio
data system (RDS). For more
information on the RDS, see page
.
Use the selector knob to
tune the radio to a desired frequency.
Turn the knob right to tune to a
higher frequency, or left to tune to a
lower frequency.
Each time you press and release
either side of the SKIP bar, the radio
frequency changes in small
increments.
The scan function samples
all stations with strong signals on the
selected band. To activate it, press
the SCAN button, then release it.
You will see SCAN in the display.
The system will scan for a station
with a strong signal. When it finds
one, it will stop and play that station
for about 10 seconds.
If you do nothing, the system will
scan for the next strong station and
play it for 10 seconds. When it plays
a station that you want to listen to,
press the SCAN button again.
140
To Select a Station To Play the Radio
SKIP
TUNE
SCAN
Playing the FM/AM Radio (Models without navigation system)
138
2008 Accord Coupe
Table Of Contents Main Menu