HONDA 2011 Pilot - Technology Reference Guide - Manual (Page 8)

DRIVING POSITION MEMORY SYSTEM (DPMS)
Store a driver’s seat and mirror position into memory for each remote transmitter.
Programming DPMS
HOMELINK ®
The HomeLink Universal Transceiver can be programmed to operate up to three
remote-controlled devices around your home, such as garage doors, lighting, or home
security systems.
Press and hold the button on the
remote and the HomeLink button at
the same time. Then, while
continuing to hold the HomeLink
button, press and release the button
on the remote every 2 seconds.
Does the LED blink at a faster rate within 20
seconds?
Press and hold
the HomeLink
button again. Training
complete
YES NO
HomeLink indicator
flashes for 2 seconds,
then remains on. HomeLink LED
remains on. YES NO
YES NO
Position the remote transmitter you
wish to link 1–3 inches from the
HomeLink button you want to program. 1
Press and hold the desired
HomeLink button and the button on
the remote transmitter.
Does the HomeLink indicator (LED) blink at a
faster rate after about 10 seconds?
2
a
The remote has a rolling code.
Press the “learn” button on the
remote-controlled device (e.g.,
garage door opener).
Press the programmed HomeLink
button again; the remote-controlled
device should operate.
Within 30 seconds, press and
hold the programmed HomeLink
button for 2 seconds.
a
Press and hold the programmed
HomeLink button for about a
second.
Does the device (garage door opener) work?
3
b
4
5
Training a Button
If you have any problems programming HomeLink, see the owner’s manual included
with the device you are trying to program, call HomeLink at (800) 355-3515, or
visit www.homelink.com.
Note: Each group of settings is activated by the corresponding remote transmitter
(1 or 2) when it’s used to unlock the driver’s door. When activated, each item begins
to adjust before you enter the vehicle.
1. Turn the vehicle on. Shift into
Park (P).
2. Adjust your preferred seat and
outside mirror settings.
3. Press and hold the SET button
until you hear a beep, then release.
4. Press and hold the memory
button corresponding to the
remote (1 or 2) you are using
until you hear two beeps.
12 13
TTRRNNGG EEXX EEXXLL EEXXLLNN TTRRNNGG
11 PilotTRG:ATG_NEW STYLE 1/26/2010 12:37 PM Page 8
2011 Pilot