HONDA 1984 Accord Coupe - Owner's Manual - Manual (Page 480)

479
uu Replacing Light Bulbs u Brake/Taillight, Back-Up Light, Rear Turn Signal Light and Rear Side Marker Light Bulbs
Main
tenan
ce
Brake/Taillight, Back-Up Light, Rear Turn Signal
Light and Rear Side Marker Light Bulbs
When replacing, use the following bulbs.
1. Remove the cargo hook by squeezing the
tabs on both sides.
2. Remove the holding clips using a flat-tip
screwdriver, then pull the lining back.
3. Turn the socket to the left and remove it.
4. Remove the old bulb and insert a new bulb.
Brake/Taillight: 21/5 W
Back-Up Light: 16 W
Rear Turn Signal Light: 21 W (Amber)
Rear Side Marker Light: 3CP
1 Brake/Taillight, Back-Up Light, Rear Turn Signal Light and Rear
Side Marker Light Bulbs
When removing the clip, insert a flat-tip screwdriver,
then lift and remove the clip.
Insert the clip with the pin raised, and push until it is
flat.
Clip
Push until the
pin is flat.
Holding Clip
Tabs Cargo Hook
Bulb
Socket
14 ACCORD 2D-31T3L6100.book 479 ページ ２０１４年３月１４日 金曜日 午後４時４５分