Guardian Technologies H1300 User Manual

Page 4

E-6

E-7

ProblEM

SolUtioN

Water mist and humidity

are not produced.

Power Plug: Unplug and then try again.
Power Failure: When the power is returned, try again.
Water Tank Installation: Make sure the water tank is

correctly attached. Make sure spring on tank

cap moves freely when pushed.

Air blows but water mist

is not produced.

Excessive Water: Remove water tank. Empty a small

amount of water from the base of the unit.
The desired humidity is lower than the current

temperature: Increase the desired humidity.
Detergent residue in the tank: Wash the tank out and try

again.

Humidity level is low.

The surface of the ultrasonic disk is dirty. Clean with

white vinegar.
The water in the unit is too cold: Replace with cool, but

not cold water.
If ultrasonic disk is damaged contact

customer Service at 1.866.603.5900.

Warm humidity is not produced.

It may take 10-15 minutes before warm humidity is cre-

ated. The mist may not feel warm to the touch.
Check to see if base of unit feels warm to the touch;

if so then warm mist is being produced.

The humidity has a bad smell.

Poor maintenance or dirty water: Clean the product

thoroughly, and fill it with fresh water.

White dust is forming on

nearby furniture.

Hard water will deposit a certain amount of dust. Dust

in the air settles because of the added humidity in the

room.

*Use distilled water if this becomes a nuisance.

Or order a decalcification Filter (Fltdc20)

by calling 1.866.603.5900 or

visiting www.guardiantechnologies.com.

Light on front of unit is red.

Water tank needs to be refilled.

Tank won't align properly back onto

base of the unit.

Tank only fits on base in one direction. Try turning the

tank around until it fits securely in place.

Red/pink film or residue build-up on

or around the ultrasonic disk.

See cleaning instructions within manual.

Clean humidifier more frequently.

To the consumer, Guardian Technologies LLC warrants this product to be free of defects in

materials or workmanship commencing upon the date of the original purchase. Save your

original sales receipt to validate start of the warranty period.

If this product should become defective within the warranty period, we will repair or replace

any defective parts free of charge. The complete machine must be delivered pre-paid to the

authorized Guardian Technologies LLC warranty service center at the address below. Please

include complete information on the problem, date of purchase, copy of original sales receipt

and your name, address and telephone number. Call for assistance in the US or Canada at

1.866.603.5900. Use only genuine Guardian Technologies replacement parts.

The warranty does not include unusual wear, damage resulting from accident or

unreasonable use of the product. This warranty does not cover unauthorized repairs. This

warranty covers product that was purchased from an authorized distributor. This warranty

gives you specific legal rights and you may also have other rights (other rights may vary from

state to state in the U.S.A.).

We consider the registration process important to ensuring superior service to our

customers, however submitting the warranty card to Guardian Technologies LLC is optional

and does not affect your rights to utilize this warranty according to the conditions stated

above. If you have any questions or comments about our product call toll free at 1.866.603.5900

or send comments to:

this warranty can also be registered online at www.guardiantechnologies.com.

attN customer Service

Warranty Service center

Guardian technologies llc

7700 St clair avenue

Mentor, ohio 44060

Guardian technologies llc

7700 St Clair Avenue | Mentor, Ohio 44060

1.866.603.5900 | www.guardiantechnologies.com

This product has been tested and complies with the requirements

for Federal Communications Commission, Part 18 for Radio/TV/

Communication interference. Although tested, it may affect these

devices. If the humidifier is found to interfere, separate the device

and/or the humidifier. Conduct only the user maintenance found in

this manual. Other maintenance and servicing can cause harmful

interference and can void the required FCC compliance.