Guardian Technologies H8000B - Manual (Page 4)

E-6 E-7
1. Separate the tank from the
base of the unit.
2. Flip over water tank and open the
tank lid, turning it to the left.
3. Pour cool, clean water directly
into the tank. Do not pour anything
but water into the tank.
4. Close the tank lid, turning it to the right.
It is important to FIRMLY secure cap after
filling the tank with water.
SET Up
Select a firm, level, flat location - at least six inches (15 cm) from any wall or object for proper air
flow. Place the humidifier on a water-resistant surface, as water can damage furniture and some
flooring. Do not place unit directly on carpet, towels, blankets or other absorbent surfaces.
Guardian Technologies will not accept responsibility for damage caused by water spillage.
FILLING
Make sure unit is unplugged.
DIRECTIONS FOR USE DIRECTIONS FOR USE
8. Select Desired Settings
See”Control Operation” section for available
unit functions. Note: When you power “on”
the humidistat reading range is from 15% to
90%. If the room humidity is below 15%, the
display reading will flash.
%
7. power button
Before turning on make sure there
is water in the unit. Press the
Power button.
5. Attach the tank to the base of the
unit and plug in.
AUTO
6. Extension Wands
If desired, assemble extension wands by
fitting ends together. Remove mist cap and
store for use without wands. Then attach
wands to humidity spout. The wands will
extend the mist to a higher level in the air
to help disperse throughout the room.
9. Water Level Window &
Auto Shut Off Feature
The tank includes a water level window so
you can easily see when it is time to refill with
water. The unit will automatically shut off
and a low water icon will blink on the display
panel if the water level is too low. If this
happens, unplug the unit, remove the tank
and refill.
AUTO
%