Guardian Technologies H1510 - Manual (Page 4)

E-6 E-7
1. Separate the tank from the
base of the unit.
2. Flip over water tank and open the
tank lid, turning it to the left.
3. Pour cool, clean water directly
into the tank. Do not pour anything
but water into the tank.
4. Close the tank lid, turning it to the right.
It is important to FIRMLY secure cap after
filling the tank with water.
5. Attach the tank to the base of the
unit and plug in.
6. Power Button
Before turning on make sure there
is water in the unit. Turn the
Power button.
1. Night Light Feature
Turn Night Lamp dial to illuminate
the night light.
2. Variable Mist Control Dial
Turn the Mist Control dial to select
the amount of mist you prefer.
4. Water Refill Indicator
When the unit is low on water the Refill
LED on the front panel will light up, and
the unit will shut off. Simply add more
water to continue use. Unit will
automatically resume running when
water tank has been refilled.
5. Humidity Spout Dual Direction
Broaden mist in two different
directions throughout the room by
rotating top section.
MIST
POWER WARM OFF COOL
LIGHT
NO WATER
SET UP
Select a firm, level, flat location - at least six inches (15 cm) from any wall or object for proper air
flow. Place the humidifier on a water-resistant surface, as water can damage furniture and some
flooring. Do not place unit directly on carpet, towels, blankets or other absorbent surfaces.
Guardian Technologies will not accept responsibility for damage caused by water spillage.
FILLING
Make sure unit is unplugged.
DIRECTIONS FOR USE DIRECTIONS FOR USE
Rotates
separately
CONTROL OPERATION
3. Cool or Warm Humidification Indicator
Select cool or warm mist. Water
temperature is maintained at room
temperature for cool setting and
80 degrees for warm. Allow 15 minutes
for water to warm.
POWER
OFF
COOL
WARM
LIGHT
NO WATER
POWER
OFF
COOL
WARM
LIGHT
NO WATER