Great Planes FlyLite EP Slow Flyer Rx-R - GPMA6004 - Manual

❏
1. Follow steps 3 and 4 on page 6 of the ARF
manual to fi t the landing gear and prepare the
battery tray.
❏
2. Connect the elevator servo to the elevator
channel on your receiver. Connect the rudder servo
to the aileron channel on the receiver. Connect
the ESC signal lead to the throttle channel on the
receiver. Test for proper operation of all servos and
the motor. If the motor rotates the wrong direction,
unplug and swap the position of any two motor wires.
Then, mount your receiver in the model using the
piece of double-sided foam tape that was provided
in this kit.
❏
3. To fi nish assembly and set up of this model,
please complete all of the steps in the ARF manual
starting on page 10 at the sub-heading,
“Mount the
Horizontal and Vertical Stabilizers.”
❏
4. The following two LiPo battery choices are
now available. If you want to use the larger 640mAh
battery, use a hobby knife to trim the side wall of the
battery compartment to allow for easy installation
and removal of the battery.
●
Preferred for Indoor Flying
ElectriFly LiPo 300mAh, 2S, 7.4V, 20C BP series
(GPMP0700)
●
Preferred for Outdoor Flying
ElectriFly LiPo 640mAh, 2S, 7.4V, 15C BP series
(GPMP0704)
Assembling Your FlyLite Rx-R ™
Thank you for purchasing the Receiver-Ready version of the ElectriFly ™ FlyLite ™ model. Your model
comes equipped with two servos, a brushless motor, and a brushless ESC. All you need to do is add
your receiver and a battery, and follow these simple instructions.
© 2010 Hobbico ® , Inc. GPMA6004 Mnl
™