Great Planes Super Skybolt 60 ARF - GPMA1242 - Manual (Page 20)

❏
5. Install the horn onto the throttle servo as shown. Start
with an angle approximately 30 degrees from being
perpendicular to the fuselage. This may need to be adjusted
as you set up your radio system.
❏
6. Insert the 2-56 x 36" [914 mm] pushrod into the outer
pushrod tube with the threaded end near the engine. Install
a 2-56 nylon clevis and silicone clevis retainer onto the
pushrod and connect it to the carburetor arm.
❏
7. Make two bends in the throttle pushrod to align it level
with the screw-lock pushrod connector. Insert the pushrod
into the connector and tighten the 4-40 x 1/8" [3 mm] SHCS
against it. Cut off any excess pushrod that extends behind
the screw-lock pushrod connector.
❏
1. Locate the plywood radio tray and test fit it into the
fuselage as shown. Be sure there is enough room at the aft
end of the plate for hook and loop material to secure the
receiver and battery. When satisfied with the fit, glue the
plate into position.
❏
2. Cut the included 14" [356 mm] hook and loop material
into two equal lengths. Create straps by overlapping the ends
by approximately 4" [102 mm].
❏
3. Wrap your receiver and receiver battery in foam rubber
and connect the servos, aileron Y-harness, and receiver
switch. Secure the receiver and battery to the mounting
plate using the straps you created.
Install the Receiver & Battery
20