beautypg.com

Turn and lane-change signals, Turn and lane-change signals -8, Turn and – GMC 2005 Savana User Manual

Page 122: Lane-change signals

background image

L

Windshield Washer. See Windshield Washer

on page 3-10.

I

Cruise Control. Cruise Control on page 3-10.

For information on the exterior lamps, see Exterior
Lamps
on page 3-13 later in this section.

Turn and Lane-Change Signals

The turn signal has two upward (for right) and two
downward (for left) positions. These positions allow you
to signal a turn or a lane change.

To signal a turn, move the lever all the way up or down.
When the turn is finished, the lever will return
automatically.

An arrow on the instrument
panel cluster will flash in
the direction of the
turn or lane change.

To signal a lane change, just raise or lower the lever
until the arrow starts to flash. Hold it there until you
complete your lane change. The lever will return by itself
when you release it.

If you move the lever all the way up or down, and the
arrow flashes at twice the normal rate, a signal bulb may
be burned out and other drivers may not see your
turn signal.

If a bulb is burned out, replace it to help avoid an
accident. If the arrows don’t go on at all when you signal
a turn, check for burned-out bulbs or a blown fuse.
See Fuses and Circuit Breakers on page 5-93.

Turn Signal On Chime

If your turn signal is left on for more than 3/4 of a mile
(1.2 km), a chime will sound at each flash of the
turn signal. To turn off the chime, move the turn signal
lever to the off position.

3-8