Optimize the working life of the battery – Philips QC5170/60 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
To Charge/Recharge
I Fully charge Clipper before using for the first
time or after non-use for a long period of time.
I
Battery performance is best if you recharge
only when the battery is (almost) completely
empty.
I
Charging, recharging, or using Clipper at
temperatures below 40°F or higher than 95T
adversely affects lifespan of the battery.
I
Continuously recharging Clipper will reduce
lifespan of battery.
D Be certain Clipper is OFF.
a
Insert the appliance plug directly into
the Clipper and plug the adapter into any
120V AC outlet (fig 1). Use only the cord
provided.
Q After a few moments, the Charging Light on
the appliance will light to indicate the Clipper
is charging.
I It will take approximately 8 hours to fully
charge the Clipper for a cordless clipping
time of up to 60 minutes.
NOTE: After the Clipper is fully charged, the
Charging Light will remain lit.
□ Disconnect the cord and unplug from
electrical outlet.
Optimize the working life of the battery
I After the Clipper has been charged for the first
time, do not recharge the Clipper between
clipping sessions. Continue using it until the
battery is completely empty.
I
Do not charge for more than 24 hours.
I
Do not keep cord permanently plugged in.
I Discharge/run down the battery completely
twice a year by letting the motor run until it
stops.
I If the Clipper hasn’t been used for a long
period of time, it must be recharged for a
full 8 hours.
I If the Clipper is exposed to a major change
in temperature, pressure or humidity, wait 30
minutes before using.
Corded Hair Clipping
I Only use the Clipper corded when the battery
is empty.
I Clipper does not recharge during corded
clipping.
D
Connect cord provided to Clipper and plug
Clipper into electrical outlet (fig. 1).
B If battery is completely empty, wait a few
minutes before switching Clipper ON.
B
Slide ON/OFF switch ON to begin clipping.
□ Turn Clipper OFF and unplug.
Cordless Hair Clipping
D
Charge according to directions. Unplug
Clipper from outlet and remove cord.
B
Slide ON/OFF switch ON to begin clipping.
B
If the charge runs out while clipping, simply
connect cord provided to Clipper and outlet
to continue clipping.