Futaba 10J - Manual (Page 83)

This screen registers the telemetry sensors used
with the transmitter. When only one of a certain
type of sensor is used, this setting is unnecessary
and the sensor can be used by simply connecting it
to the S.BUS2 port of the transmitter.
When using 2 or more of the same kind of
sensor, they must be registered here.
[What is a slot?]
6HUYRVDUHFODVVL¿HGE\&+EXWsensorsDUHFODVVL¿HGLQXQLWVFDOOHG"slot". There are slots
from No. 1 to No. 31.
$OWLWXGHVHQVRUV*36VHQVRUV and other data sensor units may use PXOWLSOHVORWV.
Using a sensor which uses two or more slots, the required number of slots is automatically
assigned by setting up a start slot.
When 2 or more of the same kind of sensor are used, the sensors themselves must allocate
unused slots and memorize that slot.
Assignable slot
*Altimeter, GPS, and other sensors that display a large amount of data require multiple slots.
*Depending on the type of sensor, the slot numbers that can be allocated may be limited.
6(16256/27
㌣6%67
㌣6%6$
6%6$
6%6$
㌣6%69
㌣6%6502
6(16256/27
6%69
6%6*
6%6*
6%6*
6%6*
㌣6%6*