Futaba 6D, 6DN - Manual (Page 8)

6. Connectors are made as shown in the above diagram. Please make certain that each connector is fully plugged
in and that the Aileron section etc., and the power supply switch harness is correctly identified.
7. After making certain that the connections are correct according to the above diagram, turn on the transmitter
switch and then put the receiver switch to ON position. At this point each Servo will stop at the Neutral
position.
8. Move each stick and Trim lever and check to see if the specific Servo is actuated correctly.
9. When each section is tested for movement, please make certain that both the Transmitting and Receiving
antennas are fully extended. If the Transmitting antenna is shortened and the Transmitter switch is left ON
for more than 5 minutes, the transistors in the Transmitter will be damaged.
10. If the system does not operate after completely assembling the batteries, switch harness and Servos for the
receiver and the Transmitter, the problem may be due to damage during shipment. Do not attempt to open
any of the units, but return them for exchange.
7