Fredenstein Bento 2 - Manual (Page 2)

Fredenstein Bento 2 Module Carrier
The Fredenstein Bento 2 is a high performance two module carrier for Fredenstein Series 600
modules or API-500 compatible plug-in cards. The unit can accept a maximum of 2 modules.
The Bento 2 features several important upgrades compared with third party products:
Universal power supply: Mains voltages range from 90V AC to 240V AC, 50 to 60 Hz.
Increased output currents: +-16V DC 0.9A and +48V DC 0.033A
Additional TRS inputs and outputs, parallel to the XLR connectors.
Built-in Audio Routing: Slot 1 can be daisy-chained to slot 2 by simply flipping a switch on the
back-panel.
Compressor buss linking: Compressor modules can be linked by engaging a switch on the back-
panel as well.
Secondary power-switch and voltage indicators on the front-panel.
Installation:
Electrical Safety Warnings:
Do not open the enclosure, hazardous voltages are present inside!
There are no user serviceable parts inside.
Always disconnect the mains cord before installing or removing modules!
If you need to replace the mains fuse, make sure the replacement has the same
rating (0.5AT 250V).
Please disconnect the mains from your Bento 2 before installing or removing modules. Make sure
each installed module is well seated in the receiving connector and the module is secured by fasten
the two mounting screws.
Front View:
Fredenstein Bento 2 Manual V1.1 July 18, 2014 Page 1