Flintec FRD-100 LCD - Manual (Page 2)

... the right weigh
FRD-100 BL Manual page 2 of 7
1. SAFETY INFORMATION ................................................................... 2
2. CHARACTERISTICS.......................................................................... 3
DISPLAY ........................................................................................................... 3
MECHANICAL .................................................................................................... 3
ELECTRONICS ................................................................................................... 3
CABLE ASSIGNEMENT ........................................................................................ 4
3. OPERATION NOTES ......................................................................... 4
INSTALLATION NOTES....................................................................................... 4
NORMAL BEHAVIOUR......................................................................................... 5
STANDARD DATA PROTOCOL DESCRIPTION........................................................ 5
4. SERVICE AND CONTACT INFORMATION......................................... 7
1. Safety Information
All products of this series are developed, manufactured and tested in accordance with
the applicable industry safety standards. If these products are properly installed,
operated and maintained according to the applicable technical instructions, drawings
and specifications, no hazard exists in the normal and intended use of these products.
General Safety Guidelines
The following general safety guidelines apply to all Flintec - products:
All applicable safety and accident prevention recommendations must be
observed (VDE 0100 and VDE 0113).
All installation, start-up and maintenance work must be carried out by qualified
service personnel only.
An easily accessible power outlet must be located close by for devices equipped
with a main power cord and plug.
An easily accessible MAIN POWER ON/OFF switch must be provided for
equipment with permanent electrical connections.