Fieldmann FDW 2003-E User Manual
Page 13
13
USER‘S MANUAL
HIGH-PRESSURE WASHER
EN
Assembly instructions
Cleaning techniques
When cleaning with the pressure washer, some cleaning tasks can be solved with water alone,
but for most it is advantageous to use a detergent. A detergent ensures quick soaking of the dirt
allowing the high pressure water to penetrate and remove the dirt more effectively.
Application of detergent
ATTENTION! CAUTION:
Avoid working on hot surfaces or in direct sunlight to minimize a chance of the soap
damaging painted surfaces.
ATTENTION! CAUTION:
Damage may occur to painted surface if soap is allowed to dry on the surface. Wash and
rinse a small section at a time.
.Apply the solution to a DRY work surface.
Note: WETTING THE SURFACE FIRST IS NOT RECOMMENDED, AS IT DILUTES THE
DETERGENT AND REDUCES ITS CLEANING ABILITY.
Allow detergent to remain on the surface for a short time before rinsing.
Rinse with clean water under high pressure. On a vertical surface, first rinse from the bottom
up, then rinse from the top down. Hold nozzle 6 – 8 in in (15-20 cm) from the work surface at
a 45° angle using the flat spray as a peeling tool rather than a scrub brush.
Note: Ensure that the detergent injection system is completely clean prior to switching from
one detergent to another