Fieldmann FZD 4020-E - Manual (Page 17)

17
OPERATING INSTRUCTIONS ELECTRICAL SHREDDER
EN Cleaning, maintenance and ordering of spare parts
If you do not intend to use the shredder for a lengthy period, protect it from corrosion using
environmentally friendly oil.
Store the device in a dry room.
Store the device out of reach of children.
When you have finished your work, pull the loading funnel forwards and clean the inside.
Use a brush to remove deposits from metal parts on the inside. Apply a thin coating of oil to
the cleaned blade plate and blades.
When you close the loading funnel, make sure that the safety switch and the release screw
are clean.
Replace, sharp and change blades
The blades on the blade plate are replaceable. If you have to replace any blade, you must only use
genuine blades to ensure that they meet the relevant quality and safety criteria.
Please note: For safety reasons we recommend that you have all sharpening and blade
replacement work carried out by a specialist workshop.
Always wear heavy duty working gloves
Secure the rotary disk so that it cannot rotate (for example by jamming it with a screwdriver,
see Figure 12b)
Undo the four blade screws and remove the blades
Each of the blades can be turned once as they are ground sharp on both ends. Then they
must be replaced by new blades.
To assemble, proceed in reverse order.
Ordering replacement parts
Please quote the following data when ordering replacement parts:
Type of machine
Article number of the machine