Fieldmann FZN 2001-E - Manual (Page 13)

EN
ELECTRIC HEDGE TRIMMER USER'S MANUAL
12 What to do "when..."
9. WHAT TO DO "WHEN..."
The following table describes the inspections and procedures you may perform if your tool is not
working properly. If these instructions do not help in identifying or remedying the problem, please
contact an authorised service centre.
WARNING!: Turn off the tool and disconnect the power plug from the socket before troubleshooting.
When... Possible cause Remedy
The hedge trimmer
is not working – No power supply
– Faulty power socket
– Damaged extension cord – Check the power supply
– Try a different power socket, replace it
– Check the power cord and if necessary replace
it (Contact an authorised service centre)
The hedge trimmer
is not work
intermittently – Damaged extension cord
– Internal electrical wiring fault
– Damaged power switch
– Check the power cord and if necessary
replace it
– Immediately contact an authorised service
centre
– Immediately contact an authorised service
centre
The motor is running
but the blades are not
moving – Internal fault – Immediately contact an authorised service
centre
The trimmer's cutting
blades are hot – Blades are blunt
– Trimmer's cutting blades are deformed
– Excessive friction caused by an insuffi cient
amount of lubricant
– Have the blades sharpened
– Have the blades repaired
– Use a lubricant in a spray