Fieldmann FZN 4001-A - Manual (Page 15)

EN
CORDLESS GRASS SHEAR & HEDGE TRIMMER USER'S MANUAL
14 Maintenance and storage
8. MAINTENANCE AND STORAGE
Maintenance
ATTENTION: Disconnect the charger if you will not be using it for a long time, if you are changing
the tool or performing maintenance on the tool.
Check whether the device is showing signs of wear.
If the charger is damaged (cover, conductors or connector), immediately arrange their replacement
at an authorised service centre or from the vendor.
Regular care for the machine will ensure not only a long lifetime and performance
Before use always visually check for worn or damaged parts.
Replace damaged or worn parts. To ensure that the machine always remains balanced, always
replace the entire set of the worn or damaged tools.
Worn or damaged machine parts may only be replaced at an authorised service centre or arranged
by the vendor.
Before cleaning disconnect this product from the power source.
To clean the plastic parts of the product, use a soft cloth dipped in lukewarm water. Do not use
aggressive cleaning products and solvents as this could damage the surface of the appliance.
Do not clean the machine under running water or submerge under water.
After changing the working tool, check that the working tool is secured in its storage position.
After each use of the shear the blade must be cleaned and lubricated. If the shear is used non-stop
for extended periods of time, lubrication should be performed during work.
Storage
Store the tool in a dry location at a suffi cient distance from heat sources or dangerous vapours.
Do not place any other items on the machine.