Expert Sleepers Augustus Loop v1.8.0 - Manual (Page 21)

PingPong
Mono-ize & Init Pan
These controls let you convert a stereo input signal into a mono
one, which is useful when you have the delay taps configured as
a ping-pong effect. 'Mono-ize' controls the degree to which the
signal is converted to mono (from 0.0 meaning no conversion to
1.0 meaning fully mono). 'Init Pan' controls the position in the
stereo field of the mono signal.
Levels
Dry
Controls the amount of the input signal that is
fed directly to the plug-in's output.
The level meter to the left of the ‘Dry’ knob
shows the level of the signal entering the plug-in.
The slider to the left of the meter sets the trigger
level (see
below ). The small button at the bottom right of the meter increases the meter
sensitivity, which can be useful when setting the trigger level on signals with a low noise
floor.
Effect
Controls the amount of the effect signal that is output from the plug-in.
The level meter to the right of the ‘Effect’ knob shows the level of the signal after the filter
section, but before the effect level has been applied (see the
overview diagram ).
Input
Controls the amount of the input signal that is fed into the delay loop.
Loop
Tap Rec
When first clicked,
• silences the effect output
• sets the pitch to 0.0
• turns off the 'reverse' feature