Vertical Communications DX-80 - Manual (Page 45)

Page 42 P7292 DETUG 09/01
4.2. To program a feature code, press [ftr].
FTR CODE:_
bksp save chg
4.2.1. Press the
!
button.
4.2.2. Input the feature code
6/
(for CID Table review) and
then press [save].
5. Continue programming other Flexible Feature Buttons or lift/replace
the handset to exit this programming.
Headset Mode !9/
All Digital Speakerphones have a standard 2.5 millimeter headset jack.
When Headset Mode is selected (either by pressing a preprogrammed
headset feature key or dialing the Headset Mode code), the button is
used to activate/deactivate the headset.
When you press the button, Headset Mode active and the extension
status changes to an off-hook condition. When you press the button
again, the extension status returns to idle, disconnecting any call in
progress.
Operation – Activate Headset Mode
1. While the telephone is idle, press
!9/
or press the Flexible
Feature button designated as HEADSET MODE (if available). The
display indicates the new status:
HEADSET ENABLED
Operation – Deactivate Headset Mode
1. While the telephone is idle, press
!*9/
or press the Flexible
Feature button programmed with the Headset Mode code. The display
indicates the new status:
HEADSET DISABLED
Operation – Use the Headset to Place a Call
1. While the telephone is idle, press , a DSS button, or outside line
button. The button LED flashes to indicate that the headset is
active. You hear Intercom dial tone, outside line dial tone, or Intercom
ring-back tone, depending on the function invoked.
2. Press again to disconnect the current call.