Grounding instructions, Installation – Emerson Radio MW1188W User Manual
Page 6
GROUNDING INSTRUCTIONS
INSTALLATION
This appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk
of electric shock by providing an escape wire for the electric current. This appliance is equipped with
a cord having a grounding wire with a grounding plug. The plug must be inserted into an outlet that
is properly installed and grounded.
WARNING: Improper use of the grounding plug can result in a risk of electric shock. Consult a qualified
electrician or service personnel if the grounding instructions are not completely understood, or if doubt
exists as to whether the appliance is properly grounded.
If it is necessary to use an extension cord, use only a three wire extension cord that has a three blade
grounding plug, and a three slot receptacle that will accept the plug on the appliance. The marked rating
of the extension cord should be equal to or greater than the electrical rating of the appliance.
1.
Steady, flat location: When positioning the microwave oven, it should be set on a steady, flat surface.
2.
Ventilation:
If they are blocked during operation, the oven may overheat
3.
Radio and TV reception: Poor television reception and radio interference may result if the oven is located
close to a TV, radio, antenna, or antenna wire. Position the oven as far from them as possible.
4.
Temperature and moisture: Keep the oven away from hot air, steam or splashing liquids when choosing
a place to locate it, otherwise, the unit’s operation may be adversely affected, causing it to break down.
5.
Power supply:
• Check your local power source. This microwave oven requires a
120V, 60H ,1 Amp power supply.
• Use a receptacle that will accept the ground prong.
(a) A short power supply cord is provided to reduce the risks resulting from becoming entangled in or
tripping over a longer cord.
(b) Longer cord sets or extension cords are available and may be used if care is exercised in their use.
(c) If a long cord or extension cord is used, (1) the marked electrical rating of the cord set or extension
cord should be at least as great as the electrical rating of the appliance, (2) the extension cord must
be a grounding-type 3-wire cord, and (3) the longer cord should be arranged so that it will not drape
over the counter top or tabletop where it can be pulled on by children or tripped over unintentionally.
6. Examine the oven for any damage such as: Dents, a misaligned door, broken door or a dent in the
cavity. If any of the above are visible, DO NOT INSTALL THE UNIT. Notify the dealer immediately.
3-pronged
Receptacle
Receptacle
Box Cover
3-pronged
plug
When using a 3-pronged plug
Receptacle
Receptacle
Box Cover
Grounding
Adapter
Grounding Lead
Screw
When using a grounding adapter, make sure the
receptacle box is fully grounded.
When using a 3-pronged plug
5
DO NOT BLOCK AIR VENTS.
and eventually cause oven failure. For proper ventilation,
THE OVEN'S TOP, SIDES, REAR AND THE AREA WHERE THE UNIT IS TO BE INSTALLED.
KEEP THREE INCHES OF SPACE BETWEEN
AC
3
z