EDCO SS-24 - Manual (Page 12)

E-SS24-I-0414
Printed in USA
©2014
KMS
Page 12
100 Thomas Johnson Drive, Frederick, MD 21702-4600 USA
Phone (301) 663-1600 • 1-800-638-3326
Fax (301) 663-1607 • 1-800-447-3326
Website: www.edcoinc.com
Email: [email protected] A Division of Equipment Development Company, Inc.
Check Engine Oil Before Each Operation -
Check Engine Manufacturer’s Owner’s Manual for specific
instructions.
Change Oil & Filter Every 50 Hours of Operation
(Sooner if Necessary).
Check Drive Chains Before Operation
Lubricate Weekly
Remove the maintenance door at the rear of the machine.
Drive chain is just inside in the center of the machine.
Inspect/adjust Arbor Drive and Drive
Belts -
On new machines and
after installation of new belts,
adjust belt tension after the first four hours,
then as necessary.
Loosen engine mount bolts (2)
turn jacking bolt to lift engine mount. (1)
Do not over tighten belts 70ft #s max.
Note:
To change the drive belt, the engine must be
slid forward. Loosen the engine bolts (4)
that hold the engine to the mount and slide the
engine forward to its original position. Reti-
ghten the engine bolts and follow the directions
above to retighten the arbor belts. Belts
Front
Engine
Mount
Bolts (2)
Jacking
Bolt
Arbor
Belts
Drive
Belt
Engine
Bolts (4)
Remove beltguard
for these adjustments
Drive Chain