EDCO 446 - Manual (Page 13)

E-POWERTROWELS-IP-0911.5
Printed in USA
TVW
©2011
Page 13
100 Thomas Johnson Drive, Frederick, MD 21702-4600 USA
Phone (301) 663-1600 • 1-800-638-3326
Fax (301) 663-1607 • 1-800-447-3326
Website: www.edcoinc.com
Email: [email protected]
ASSEMBLY INSTRUCTIONS
STEP 1: Un-pack the handle assembly (A) and the lower
unit from their boxes. Check to make sure no damage was
done during shipment. Mount the handle assembly (A) to
the gearbox (B) on the lower unit using 4 3/8” nylock nuts
(C) that are supplied in a package in the lower unit.
STEP 2: With the handle mounted to the lower unit, attach
the pitch control cable (A) through the yoke arm (B) using
the remaining 3/8” nylock nut (C). Tighten the nylock nut to
where there is approximately a 1/4” of the threads are
showing.
STEP 3: Attach the kill wire (A) that is coming from the
handle assembly to the engine using the wire splicer (B)
that is supplied on the lower unit.
STEP 4:
Make sure that the throttle lever on the handle
assembly is pushed all the way forward. Remove the
breather cap and the breather from the engine. Unscrew
the cable adjustment clasp (A). Next make sure that the
throttle lever (B) on the engine is pushed all the way forward .
Insert the wire coming out of the cable into the hole (C)
shown on the diagram. With everything in place, put the
cable adjustment clasp (A) back on and tighten down snug.
2A-1
2A
ASSEMBLY