Ecler VERSO SB115P - Manual (Page 6)

6
5. PLACEMENT AND INSTALLATION
Please observe the following general rules:
As a subwoofer, the VERSO SB115P has been designed to be installed in discrete places.
Low frequencies are considered to be non-directional so the VERSO SB115P can be perfectly
placed in corners, under a table, behind curtains... that will not notably affect its output. Generally, it
should be known that placing it close to various surfaces will increase its efficiency. Consequently,
the sound pressure level will be higher if you place the speaker on the ground in a corner rather that
just beside a wall and even more that in the centre of a room.
On the left side of the enclosure, threads allow to install the QRA+WH200 transport wheels
accessory kit. Ask your agent for more information about it.
On the other hand, the SB115P is designed to be combined with VERSO/VERSO P series
acoustic speakers in several ways:
•
Installed independently on the floor.
•
Mounting a pole (POLE01) on the 35 mm pole mount socket of the SB115P
upper face, and a VERSO/VERSO P over it.
•
If the SB115P is used in combination with VERSO12 or VERSO12P enclosures,
these ones may be directly placed on the upper face of SB115P, using the 3
circular recesses matching the position of the VERSO12/12P rubber feet.
•
To facilitate the vertical stack of several SB115P, the unit upper face has 4
circular recesses matching the position of its rubber feet.
There is no rule governing the number of mid/high speakers per subwoofer. It mainly
depends on the subwoofer location and on the room acoustics. Thus in a highly reflective room, a
subwoofer may even damage intelligibility while several subwoofers could be necessary in a room
with highly absorptive surfaces.
Always place the speakers on solid and firm surfaces.
Although the speakers can operate outdoor, they should not be subjected to climatic stress
like sunshine or rain.
Adapt the sound pressure levels to the diffusion needs.