ebm-papst S3G990-BZ02-01 - Manual (Page 12)

Operating instructions S3G990-BZ02-01
Translation of the original operating instructions
6.1 Cleaning
NOTE
Damage to the device during cleaning.
Malfunction possible
→ Do not clean the device using a water jet or high-pressure
washer.
→ Do not use any cleaners containing acids,
bases or solvents.
→ Do not use any pointed or sharp-edged objects to clean.
6.2 Safety test
NOTE
High-voltage test
The integrated EMC filter contains Y capacitors. Therefore, the
trigger current is exceeded when AC testing voltage is applied.
→ Test the device with DC voltage when you carry out the
high-voltage test required by law. The voltage to be used
corresponds to the peak value of the AC voltage required by
the standard.
What has to
be tested? How to test? Frequency Which
measure?
Check the
protective
casing against
accidental
contact for
damage and to
ensure that it is
intact Visual inspection At least every
6 months
Repair or
replacement of
the device
Check the
device for
damage to
blades and
housing Visual inspection At least every
6 months
Replacement
of the device
Mounting the
connection lines Visual inspection At least every
6 months
Fasten
Check the
insulation of
the wires for
damage Visual inspection At least every
6 months
Replace wires
Tightness of
screwed cable
gland Visual inspection At least every
6 months
Retighten,
replace if
damaged
Condensate
discharge
holes for
clogging, as
necessary Visual inspection At least every
6 months
Open bore holes
Weld seams
for crack
formation Visual inspection At least every
6 months
Replace device
Item no. 50141-5-9970 · ENG · Revision 82539 · Release 2014-05-08 · Page 12 / 12
ebm-papst Mulfingen GmbH & Co. KG · Bachmühle 2 · D-74673 Mulfingen · Phone +49 (0) 7938 81-0 · Fax +49 (0) 7938 81-110 · [email protected] · www.ebmpapst.com