Drawmer 1968 Dual Ch Tube Compressor - Manual (Page 5)

5 DRAWMER 1968 MkII O PERATOR’S M ANUA L
The 1968 MkII unit will be supplied with a power cable suitable for domestic power outlets in your country. For your own
safety, it is important that you use this cable to connect to the mains supply earth. The cable must not be tampered with
or modified.
The power supply socket has an integral fuse drawer containing the power fuse of the same value, to suit the mains
voltage for which the unit has been supplied. Removal of the drawer is only possible with the power cord removed. The
fuse should never blow under normal operation. If the fuse is suspected of having blown, then a fault will have occurred
and this fault condition should be inspected by a qualified service engineer. When replacing the fuse, always comply with
the Safety Instructions.
If the unit is to be used with a mains input operating
voltage different to that for which the unit is supplied, the
following procedure must be carried out by a technically
competent person, (see following diagrams)
POWER CONNECTION
1: Disconnect the unit from the mains.
2: Using a number 1 size pozidrive screwdriver,
remove the seven self -tapping screws that retain the
top cover.Two screws are found along each side; two
along the top edge at the rear; and the upper central
screw on the front facia panel.
3: Slide the voltage change-over switch (SW8) until
the correct (or nearest) mains input voltage is visible
on the switch actuator.
(see fig.2)
For conversion to 115Volt AC (previously set to
230Volt AC).....
4a: Exchange the 160mA fuse below the mains
socket for a similar type rated at 315mA
For conversion to 230Volt AC (previously set to
115Volt AC).....
4b: Exchange the 315mA fuse below the mains
socket for a similar type rated at 160mA
In addition another fuse is located inside the unit.
5:The on-board fuse protects the HT circuit and is
rated at T32mA: unclip the cover and replace the
fuse;
In all cases:
6: Replace the top cover using the seven screws.
7: Re-connect to mains power source.
Fuse
fig.2 The Voltage Selector Switch
fig.3 The Location of the Fuse