Dodge 2009 Ram 3500 - Manual (Page 157)

Your vehicle should be parked outside of the garage
while training.
1. Turn the ignition switch to the ON/RUN position.
2. Place the hand-held transmitter 1 to 3 inches (3 to
8 cm) from the HomeLink
௡ buttons while keeping the
HomeLink ௡ display in view.
For optimal training, point the battery end of the hand-
held transmitter away from the HomeLink
௡.
3. Simultaneously, press and hold both the chosen
HomeLink
௡button and the hand-held transmitter button
until the indicator(s) change from a slow to a rapid flash
rate.
Then release both the HomeLink ௡ and hand-held trans-
mitter buttons.
It may take up to 30 seconds or longer in rare cases. The
garage door may open and close while you train.
If the signal is too weak to train, replace the battery in the
original hand-held transmitter.
NOTE: Some gate operators and garage door openers
may require you to replace Step #3 with procedures
noted in the “Gate Operator/Canadian Programming”
section.
4. Press and hold the just-trained HomeLink ௡ button. If
the indicator(s) blink rapidly for two seconds and then
remains constant, continue with the next section: “Pro-
gramming A Rolling Code System”.
NOTE: After training a HomeLink ௡ channel, if the
garage door does not operate with HomeLink ௡ and the
garage door opener was manufactured after 1995, the
garage door opener may have rolling code. If so, proceed
to the heading, “Programming A Rolling Code System.”
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 155
3