D.W. Fearn VT-3 - Manual (Page 10)

D.W. FEARN
VT-I/F Vacuum Tube Instrument Interface
11
D e s c r i p t i o n
The D.W. Fearn model VT-3 Vacuum Tube DI is designed to provide recording
professionals with a sonically superior method for recording electric and electron-
ic musical instruments by direct injection (DI). Any instrument designed to oper-
ate into a “guitar amp” will work perfectly with the VT-3. Typical instruments
include: electric bass, electric guitar, electric piano, acoustic instruments with a
pickup (piano, acoustic guitar, electric violin, etc.), synthesizers, and samplers.
The VT-3 is a two-channel device that provides the optimum load impedance for
these instruments. It is capable of quality reproduction of a wide range of instru-
ment levels. The unit does not have the limitations of passive transformer-type
DIs, and has greater headroom and warmth when compared to similar solid-state
devices.
It is designed to operate in the professional recording or performing environ-
ment. The output level is “hot” mic level (-30 dBm nominal). The output is trans-
former-balanced, using a custom transformer built for us by Jensen Transformers,
Inc., and is designed to match 150 ohm professional mic inputs. Top-quality parts
are used throughout. Both the filament and plate power supplies are fully regulat-
ed.
The VT-3 is not mass-produced. Each one is hand-made and meticulously test-
ed before shipment to the customer.