Cabletron Systems THN-MIM - Manual (Page 7)

INTRODUCTION
Page 1-2
can be connected directly to the module. Each of these segments
supports one device.
The entire THN-MIM or each port on the MIM can be controlled via the
IRM in your MMAC. The IRM can be accessed directly through a
console port on the front panel or be controlled and managed in-band
using Cabletron Systems Remote LANVIEW/Windows
™ ,
SPECTRUM ® , or SNMP compliant network control management
software.
Each port on the THN-MIM has two LANVIEW ® LEDs, the Port OK
(POK) LED and the Receive (RCV) LED. The POK LED remains lit as
long as the port is connected to the network. If a port is segmented from
the network, the LED will not be lit. The RCV LED will be lit when
activity is detected on the segment. These LEDs help diagnose physical
layer problems as they arise.
1.2 USING THIS MANUAL
This manual provides instructions on installing the THN-MIM into
the MMAC, attaching coaxial segments to the MIM, and testing those
segments after they have been attached to the MIM.
This manual assumes that the user has a general working knowledge
of Ethernet, and of IEEE 802.3 type data communications networks
and their physical layer components.
If additional support is needed related to the Cabletron Systems
THN-MIM, or if you have any additional comments, improvements,
suggestions, or questions, feel free to contact Cabletron Systems
Technical Support at:
Cabletron Systems
P.O. Box 5005
Rochester, NH 03867-0505
Phone: (603) 332-9400
1.3 SPECIFICATIONS
Listed below are the specifications for the Cabletron Systems
THN-MIM.