Continental CVF36P - Manual (Page 2)

2
W415-0298 / K / 12.06.07
PG 3-4 INTRODUCTION
Warranty
General Instructions
General Information
Care of Glass Door, Catalytic Tiles &
Plated Parts
5-7 INSTALLATION
Combustion and Ventilation Air Provisions
Determining Confi ned or Unconfi ned Space
Gas Installation
Optional Wall Switch Installation
Dimensions
Minimum Framing Clearances
Nailing Tab Installation
Minimum Mantel and Enclosure Clearances
8-9 FINISHING
Grate and log installation
Charcoal Embers
Glowing Embers
Hood Installation
Logo Placement
Louvre Installation
9-10 OPTIONAL BLOWER
INSTALLATION
GD65 Fan Installation
GD36 Termostatic Sensor Control
11-12 OPERATION / MAINTENANCE
Operating Instructions
Maintenance
Oxygen Depletion Sensor Pilot Cleaning
Pilot Flame Appearance
Venturi Adjustment
13-14 REPLACEMENTS
Ordering Replacement Parts
Replacement Parts
Accessories
15-16 TROUBLE SHOOTING GUIDE
17 SERVICE HISTORY
18 NOTES
TABLE OF CONTENTS
PLEASE RETAIN THIS MANUAL FOR FUTURE REFERENCE
• Under no circumstances should this heater be modifi ed
• Provide adequate ventilation and combustion air. Provide adequate accessibility clearance for servicing and operating
the heater. Never obstruct the front opening of the heater.
• If the heater shuts off, do not re-light until you provide fresh air. If heater keeps shutting off, have it serviced. Keep
burner and control compartment clean.
• Do not burn wood or other materials in this heater.
• Adults and especially children should be alerted to the hazards of high surface temperatures and should stay away to
avoid burns or clothing ignition. Keep young children and animals away when the fi replace is hot.
• Due to high temperatures, the heater should be located out of traffi c and away from furniture and draperies.
• Clothing or other fl ammable material should not be placed on or near the heater.
• Any safety screen or guard removed for servicing must be replaced prior to operating the heater.
• It is imperative that the control compartments, burners and circulating blower and its passageway in the fi replace
and venting system are kept clean. The fi replace and its venting system should be inspected before use and at least
annually by a qualifi ed service person. More frequent cleaning may be required due to excessive lint from carpeting,
bedding material, etc. The fi replace area must be kept clear and free from combustible materials, gasoline and other
fl ammable vapours and liquids.
• Furniture or other objects must be kept a minimum of 4 feet away from the front of the fi replace.
• Do not use this fi replace if any part has been under water. Immediately call a qualifi ed service technician to inspect the
fi replace and to replace any part of the control system and any gas control which has been under water.
• Do not allow fans to blow directly into the fi replace. Avoid any drafts that alter burner fl ame pattern.
• Do not use a blower insert, heat exchanger insert or other accessory not approved for use with this heater.
NOTE: CHANGES, OTHER THAN EDITORIAL, ARE DENOTED BY A VERTICAL LINE IN THE MARGIN.
! WARNING