C. Crane Twin Coil Ferrite - Manual (Page 6)

The first time you use the Twin Coil Ferrite AM Antenna by C. Crane
it takes time, planning, and a little bit of patience. You will need to
re-check and re-tune the unit to find the best position. After you have
found the best spot for the TUNER CONTROL, FERRITE STICK,
and ANTENNA ELEMENT, you can take the time to secure and
make permanent the installation to your liking. The FERRITE STICK
can be fixed to the radio using the included hook and loop fastener.
If you have a problem finding a location for the ANTENNA
ELEMENT that produces good results, be sure to try different areas
within 50' of your radio. If you find a good position, you have the
option of locating the ANTENNA ELEMENT there. If you need to
mount the ELEMENT away from the radio for best reception, you
may order additional cable in 25' or 50' lengths. Please refer to the
inside cover of this manual for optional accessories.
To use the Twin Coil Ferrite AM Antenna with a radio that does not
have antenna connectors:
1. Find the patchcord with the
1/8" x RCA male connector.
2. Insert the RCA plug into the
FERRITE STICK.
3. Insert the other end of the
patchcord into the jack
labeled To Radio on the
TUNER CONTROL. (See
photo on page 5.)
Page 6 Twin Coil Ferrite ™ AM Antenna by C.Crane
Getting Started
Using the Twin Coil Ferrite ™ AM Antenna by C.Crane
With a Portable Radio
RCA
Connecto r
Ferrite
Stick