Crosley 2211602 User Manual
Side by side refrigerator
Table of contents
Document Outline
- SIDE BY SIDE Refrigerator
- Refrigerator Safety
- ProperDisposalof YourOldRefrigerator
- Installing Your Refrigerator
- TOOLS NEEDED: Z\v in. hex-head socket wrench, B\zn in. hex-head socket wrench and a flat-head scr...
- IMPORTANT: Before you begin, turn the refrigerator control OFF, unplug refrigerator or disconnect...
- Handle Removal (optional)
- Door Removal
- 1. Unplug refrigerator or disconnect power.
- 2. Open both refrigerator doors. Remove the base grille by pulling up on the bottom outside corne...
- 3. Close both doors and keep them closed until you are ready to lift them free from the cabinet.
- 4. If you have a dispenser (ice or water), disconnect the water dispenser tubing located behind t...
- 5. Remove top left hinge cover and screws as shown (see Graphic 4). DO NOT REMOVE SCREW 1.
- 6. Disconnect wiring plug and both ground wires (see Graphic4).
- 7. Carefully lift freezer door straight up off bottom hinge (see Graphic5). The water dispenser ...
- 8. Remove top right hinge cover and screws as shown (see Graphic6). DO NOT REMOVE SCREW 1.
- 9. Lift the refrigerator door straight up off bottom hinge.
- 10. It may not be necessary to remove the bottom hinge to move the refrigerator through a doorway...
- 1. Unplug refrigerator or disconnect power.
- Door and Hinge Replacement
- 1. Replace both bottom hinges, if removed. Tighten screws.
- 2. Assistance may be needed to feed the water dispenser tubing through the bottom hinge while rei...
- 3. Align and replace the top left hinge as shown (see Graphic4). Tighten screws.
- 4. Reconnect both ground wires.
- 5. Reconnect wiring plug.
- 6. Replace left hinge cover and screws.
- 7. Replace the refrigerator door by carefully lifting the door onto the bottom right hinge.
- 8. Align and replace the top right hinge as shown (see Graphic6). Tighten screws.
- 9. Replace hinge cover and screws. Tighten screws.
- 10. Plug into a grounded 3 prong outlet.
- 1. Replace both bottom hinges, if removed. Tighten screws.
- Door Closing
- Door Closing
- 1. Move the refrigerator into its final position.
- 2. The two leveling screws are part of the front roller assemblies which are at the base of the r...
- 3. Use a screwdriver to adjust the leveling screws. Turn the leveling screw to the right to raise...
- 4. Open both doors again and check to make sure that they close as easily as you like. If not, ti...
- 5. Replace the base grille.
- 1. Move the refrigerator into its final position.
- Door Closing
- ConnectingtheRefrigerator toaWaterSource
- Read all directions carefully before you begin.
- IMPORTANT:
- Cold water supply
- 1. Unplug refrigerator or disconnect power.
- 2. Turn OFF main water supply. Turn ON nearest faucet long enough to clear line of water.
- 3. Locate a º in. to 1Z\v in. (12.7 mm to 3.18 cm) vertical COLD water pipe near the refrigerator.
- 4. To determine the length of copper tubing you will need, measure from connection on lower left ...
- 5. Using a grounded drill, drill a Z\v in. hole in the cold water pipe you have selected.
- 6. Fasten shut-off valve to cold water pipe with pipe clamp. Be sure outlet end is solidly in the...
- 7. Slip compression sleeve and compression nut on copper tubing as shown. Insert end of tubing in...
- 8. Place the free end of the tubing into a container or sink, and turn ON main water supply and f...
- 1. Attach the copper tube to the valve inlet using a compression nut and sleeve as shown. Tighten...
- 1. Unplug refrigerator or disconnect power.
- Water System Preparation
- 1. Open the freezer door and turn off the ice maker. For Style 1 lift up the wire shut-off arm as...
- 2. Install the interior water filter cartridge. The interior water filter mounting bracket is loc...
- 3. Flush the water system by dispensing and discarding 2 to 3 gallons (8 to12 liters) or approxim...
- 4. Inspect the filter system for water leaks. If you see water leaks, see the “Troubleshooting” s...
- 5. Open the freezer door and turn on the ice maker. For Style 1 lower the wire shut-off arm. For ...
- 1. Open the freezer door and turn off the ice maker. For Style 1 lift up the wire shut-off arm as...
- UnderstandingSoundsYouMayHear
- Using Your Refrigerator
- EnsuringProperAirCirculation
- Setting the Controls
- Adjusting Control Settings
- Water and Ice Dispensers
- Interior Water Filtration System
- (on some models)
- Replacing the interior water filter cartridge
- 1. Twist the interior water filter cartridge Z\v turn to the left. The INSTALL mark will be lined...
- 2. Gently pull down on the cartridge to remove it from the filter mounting bracket assembly. To p...
- 3. Install the new interior water filter cartridge. You can run the dispenser without a water fil...
- 4. Line up the INSTALL mark on the water filter label with the indicator line that is molded into...
- 5. Flush the water system by dispensing and discarding 2 to 3 gallons (8 to12 liters) or approxim...
- 6. Inspect the filter system for water leaks. If you see water leaks, see the “Troubleshooting” s...
- 1. Twist the interior water filter cartridge Z\v turn to the left. The INSTALL mark will be lined...
- Replacing the interior water filter cartridge
- (on some models)
- Ice Maker and Storage Bin/Bucket
- (on some models - Accessory)
- 1. To turn the ice maker on, simply lower the wire shut-off arm.
- 1. Pull the covering panel out from the bottom and then slide it back toward the rear.
- 1. To turn the ice maker on, slide the control to the ON (left) position.
- 1. Place four fingers in bucket base opening and rest thumb on the release button.
- 1. Empty the ice container. Use warm water to melt the ice if necessary. Never use anything sharp...
- REMEMBER:
- (on some models - Accessory)
- REfrigerator features
- Refrigerator Shelves
- Lateral Adjustable Shelf
- (on some models)
- Flip-up Shelf
- Adjustable Flip-up Shelf
- Deli Drawer
- Convertible Vegetable/Meat Drawer, Crisper and Covers
- Convertible Vegetable/Meat Drawer Temperature Control
- Crisper Humidity Control
- Utility or Egg Bin
- Wine or Can/Bottle Rack
- Freezer features
- Door features
- Caring for Your Refrigerator
- Cleaning Your Refrigerator
- To clean your refrigerator:
- 1. Unplug refrigerator or disconnect power.
- 2. Remove all removable parts from inside, such as shelves, crispers, etc.
- 3. Hand wash, rinse, and dry removable parts and interior surfaces thoroughly. Use a clean sponge...
- 4. Wash stainless steel and painted metal exteriors with a clean sponge or soft cloth and a mild ...
- 5. Clean the condenser coils regularly. Coils may need to be cleaned as often as every other mont...
- 6. Plug in refrigerator or reconnect power.
- 1. Unplug refrigerator or disconnect power.
- To clean your refrigerator:
- Changing the Light Bulbs
- Power Interruptions
- Vacation and Moving Care
- Vacations
- Moving
- 1. If your refrigerator has an automatic ice maker:
- 2. Remove all food from the refrigerator and pack all frozen food in dry ice.
- 3. Empty the ice bin.
- 4. Depending on your model, turn the Thermostat Control or Refrigerator Control to OFF. See the “...
- 5. Unplug the refrigerator.
- 6. Empty water from the defrost pan.
- 7. Clean, wipe, and dry thoroughly.
- 8. Take out all removable parts, wrap them well, and tape them together so they don’t shift and r...
- 9. Depending on the model, raise the front of the refrigerator so it rolls more easily OR screw i...
- 10. Tape the doors shut and the power cord to the refrigerator cabinet.
- 1. If your refrigerator has an automatic ice maker:
- Cleaning Your Refrigerator
- troubleshooting
- Try the solutions suggested here first in order to avoid the cost of an unnecessary service call.
- Your refrigerator will not operate
- The lights do not work
- There is water in the defrost drain pan
- The motor seems to run too much
- The refrigerator seems to make too much noise
- The ice maker is not producing ice
- The ice maker is producing too little ice
- Off-taste, odor or grey color in the ice
- The ice dispenser will not operate properly
- The water dispenser will not operate properly
- Water or ice is leaking from the dispenser
- The dispenser water is not cool enough
- The divider between the two compartments is warm
- Temperature is too warm
- There is interior moisture build-up
- The doors will not close completely
- The doors are difficult to open
- Water flow from the dispenser decreases noticeably
- Try the solutions suggested here first in order to avoid the cost of an unnecessary service call.
- AssistanceorService
- Water filter certifications
- Product Data Sheets
- CROSLEY® Refrigerator Warranty