Control indicator guide – COMEUP Automotive Winch (Ver:00) User Manual

Page 5

Control Indicator Guide

b. Press and hold the Power Button for about 5 seconds, then the LED Indicator illuminates

Green permanently.

c. Press either Cable In Button or Cable Out Button for programming.

d. After the completion of programming, the buzzer sounds a long beep lasting for 5 seconds.

For Seal 9.5rsi winch, the Right LED turns off and the Left LED illuminates Green

permanently.

e. The process of the programming shall be completed within 5 minutes, if it fails to program,

turn off the power and restart the programming.

3. Start the Winch

․

For Seal 9.5rsi winch

Press and hold the Power Button for 5 seconds to start winch operation. The Left LED and

LED Indicator illuminate Green.

․

For Seal 9.5rs / 12.5rs winch

Press and hold the Power Button for 5 seconds to start winch operation. The LED Indicator

illuminates Green.

4. Shut down the Winch

a. Press and hold the Power Button for 5 seconds to stop winch function.

b. When operation of the winch is stopped for more than 5 minutes, the winch and the module

will turns off automatically. The Green LED Indicator also turns off.

5. Control Units

The wireless control module and remote control are compatible for activating the winch, but it

takes about a 10 second interval to exchange the wired remote control for the wireless control

module.

a. Blinking Red LED illuminate shows poor signal received.

b. The remote control can be used as a stand-alone, without the wired remote.

If the motor is overheating, the Left LED of Seal 9.5rsi illuminates Red and the buzzer has 2

short beeps every 5 seconds until the temperature of the motor falls within the safety range.

Only one remote can be programmed for each receiver.

Wiring Diagram

Attach the black lead firmly to the negative (–) battery terminal and red lead to the positive (+)

battery terminal. The voltage drop for the winch motor must not exceed 10% of the nominal voltage

of 12/24V DC.

LED Indicator

Cable Out

Cable In

Power Button

Left LED

Right LED

Seal 9.5rsi