beautypg.com

Accessory positions with engine off, Theft alarm, To arm – Chrysler 2012 Country - User Guide User Manual

Page 15: Getting started

background image

Stopping

• Place the shift lever in PARK.

• Press the ENGINE START/STOP button once. The ignition switch will return to the

OFF position.

If the shift lever is not in PARK, the ENGINE START/STOP button must be held for

two seconds and vehicle speed must be above 5 mph (8 km/h) before the engine will
shut off.

Accessory Positions with Engine Off

NOTE:

• The following functions are with the driver’s foot OFF the Brake Pedal (Transmission in

PARK or NEUTRAL Position).

Starting With The Ignition Switch In The OFF Position:

• Press the ENGINE START/STOP button once to change the ignition switch to the ACC

position.

• Press the ENGINE START/STOP button a second time to change the ignition switch to

the ON/RUN position.

• Press the ENGINE START/STOP button a third time to return the ignition switch to the

OFF position.

NOTE:

• If the ignition switch is left in the ACC or

ON/RUN (engine not running) position and
the transmission is in PARK, the system will
automatically time out after 30 minutes of
inactivity and the ignition will switch to the
OFF position.

THEFT ALARM

To Arm

Keyless Enter-N-Go™ button installed:

Press the Keyless Enter-N-Go™ Start/Stop button

until the Electronic Vehicle Information Center (EVIC) indicates that the vehicle ignition is
“OFF”. Press the power door lock switch while the door is open, press the Key Fob LOCK
button, or with one of the Key Fobs located outside the vehicle and within 5 ft (1.5m) of the
driver's and passenger front door handles, press the Keyless Enter-N-Go™ LOCK button
located on the door handle.

Keyless Enter-N-Go™ button not installed:

Turn the ignition switch to the “OFF” position.

Press the power door lock switch while the door is open, press the Key Fob LOCK button, or
with one of the Key Fobs located outside the vehicle and within 5 ft (1.5m) of the driver's and
passenger front door handles, press the Keyless Enter-N-Go™ LOCK button located on the
door handle.

NOTE:

After pressing the Keyless Enter-N-Go™ LOCK button, you must wait two seconds

before you can lock or unlock the vehicle via the door handle.

OFF

RUN

ACC

Press

Press

Press

GETTING STARTED

13

This manual is related to the following products: