Station presets, Electronic vehicle information center (evic), Universal garage door opener – Chrysler 2010 PT Cruiser - User Guide User Manual

Page 25: Programming homelink, Electronics

• After adjusting the hours, press the right side TUNE/AUDIO control knob and the

minutes will begin to blink.

• Adjust the minutes using the right side TUNE/AUDIO control knob, then press the

TUNE/AUDIO control knob to save the time change.

• To exit, press any button/knob or wait five seconds.

Station Presets

• Press the SET/RND button once and SET 1 will show in the display. Then select the

button (1–6).

• A second station may be added to each push button. Press the SET/RND button

twice and SET 2 will show in the display, then select button (1–6)

ELECTRONIC VEHICLE INFORMATION CENTER (EVIC)

• The EVIC features a driver interactive display that is located in the instrument

cluster. For additional information, refer to Programmable Features in this guide.

• Press the EVIC button, located below the left of the speedometer, until one of the

following functions is displayed on the EVIC:

• Compass/Temperature/Audio

• Average Fuel Economy

• Distance To Empty (DTE)

• Elapsed Time

• Tire Pressure Monitor (TPM)

• Personal Settings

• Pressing and holding the EVIC button once will clear the function currently being

displayed.

• To reset all resettable functions, press and release the EVIC button a second time

within three seconds of resetting the currently displayed function. Reset ALL will
be displayed during this three-second window.

UNIVERSAL GARAGE DOOR OPENER

Programming HomeLink

Begin Programming

• The HomeLink

buttons are located in the

sun visor.

• Erase all channels before you begin

training by holding the two outside buttons
for up to 20 seconds until the red indicator
flashes.

ELECTRONICS