beautypg.com

Programmable features, Key fob programmable features, Getting started – Chrysler 2010 300 SRT - User Guide User Manual

Page 22

background image

PROGRAMMABLE FEATURES

Electronic Vehicle Information Center (EVIC) – If Equipped

• The EVIC can be used to program the following Personal Settings. Press and

release the MENU button

until Personal Settings displays, then press the

SCROLL button

to scroll through the settings. Press the FUNCTION SELECT

button

to change the setting.

• Language

• Key-Off Power Delay

• Auto Door Locks

• AWD System Displays

• Auto UNLK On Exit

• Display ECO

• RKE Unlock

• Turn-by-Turn Navigation

• RKE Linked To Memory

• Confirmation of Voice Commands

• Sound Horn With RKE Lock

• Park ASST. System

• Flash Lamp Lock

• Display Units of Measure

• Headlamp Off Delay

• Automatic High Beams

• Easy Exit Seat

• Rain Sensing Intermittent Wipers

• Tilt MIRR. In Reverse

• Turn Headlamps On With Wipers

• Turn Headlamps On With Remote Key

Unlock

• Passive Entry

Key Fob Programmable Features

• The following features may also be programmed by using the Key Fob transmitter

or the ignition switch and driver’s door lock switch.

NOTE: Pressing the LOCK button while you are inside the vehicle will activate the
Vehicle Security Alarm. Opening a door with the Vehicle Security Alarm activated will
cause the alarm to sound. Press the UNLOCK button to deactivate the Vehicle
Security Alarm.

Unlock On First Press

• To unlock either the driver’s side, or all doors, on the first press of the UNLOCK

button:

• Press and hold the LOCK button for at least 4 seconds, but no longer than

10 seconds. Then, press and hold the UNLOCK button while still holding the
LOCK button.

• Release both buttons at the same time.

Auto Unlock Doors On Exit

• To have all of the vehicle doors unlock when any door is opened:

• Enter your vehicle and close all the doors.

• Within 15 seconds, cycle the ignition switch between LOCK and ON and then back

to LOCK four times, ending up in the LOCK position (do not start the engine).

• Within 30 seconds, press the power door UNLOCK switch to unlock the doors. A

single chime will indicate that programming is complete.

GETTING STARTED

20

This manual is related to the following products: