Chrysler 2009 300 SRT - Manual (Page 311)

To reinstall the button, position it with its lettering
oriented horizontal and readable. Gently insert the but-
ton into the receptacle by pressing on the center of the
button. If the button slips in easily, it has been installed
correctly. Press firmly on the center of the button to seat
the button into the receptacle.
The ENGINE START/STOP button should only be re-
moved or inserted with the ignition in the OFF position.
Keyless Go Functions — With Driver’s Foot Off
The Brake Pedal (In PARK Position)
• Press the ENGINE START/STOP button once (ACC
position) to activate the radio, wipers, and windows.
• Press the ENGINE START/STOP button twice (ON
position) to activate the heating/air conditioning
(HVAC) controls, and the instrument cluster.
• Press the ENGINE START/STOP button three times
(OFF position) to turn off the ignition switch.
Normal Starting
Using The ENGINE START/STOP Button
NOTE: Normal starting of either a cold or a warm
engine is obtained without pumping or depressing the
accelerator pedal.
To start the engine, the transmission must be in PARK or
NEUTRAL. From any ignition state, press and hold the
brake pedal while pressing the ENGINE START/STOP
button. The system takes over and attempts to start the
vehicle. If the vehicle fails to start, the starter will
disengage automatically after 10 seconds. If you wish to
stop the cranking of the engine prior to the engine
starting, press the button again.
STARTING AND OPERATING 309
5