Using homelink, Reprogramming a single homelink button, Security – Chrysler 2008 300 SRT User Manual
Page 184: Pinch protect feature, Pinch protect override, Venting sunroof - express, Sunshade operation, Wind buffeting
Then proceed with Step 4 under “Programming
HomeLink
” earlier in this section.
Using HomeLink
ா
To operate, simply press and release the programmed
HomeLink
button. Activation will now occur for the
trained device (i.e., garage door opener, gate operator,
security system, entry door lock, home/office lighting,
etc.) The hand-held transmitter of the device may also be
used at any time.
Reprogramming A Single HomeLink
ா Button
To reprogram a channel that has been previously trained,
follow these steps:
1. Turn the ignition switch to the ON/RUN position.
2. Press and hold the desired HomeLink
button for 20
seconds until the EVIC display states “CHANNEL #
TRAINING.” Do not release the button.
3. Without releasing the button, proceed with Program-
ming HomeLink
Step 2 and follow all remaining steps.
Security
It is advised to erase all channels before you sell or turn
in your vehicle.
To do this, press and hold the two outside buttons for 20
seconds until the EVIC message states “CHANNELS
CLEARED.” Note that all channels will be erased. Indi-
vidual channels cannot be erased.
The HomeLink
Universal Transceiver is disabled when
the Vehicle Security Alarm is active.
182
UNDERSTANDING THE FEATURES OF YOUR VEHICLE