Uniden MC 722 - Manual (Page 4)

3. The front panel can be fully reversed to provide for optimum viewing area, operat­
ing for any mounting position.
4. The EXTERNAL speaker jack may be used with an auxiliary speaker in lieu of the
built-in speaker.
5. All connections are "plug-in" type for easy removal of the radio.
ACTUAL INSTALLATION
After carefully considering the various factors affecting choice of location, position
the radio (with bracket, microphone, power plug, antenna plug and any auxiliary
plugs installed) into the selected location to assure there is no interference with
surrounding items. Mark the location of the mounting bracket. Remove the bracket
from the radio and use it as a template to mark the holes to be drilled for the mount­
ing hardware. Drill the holes and mount the bracket with hardware compatible with
the material of the mounting surface. Install the power cable (red is -t, black is -),
antenna and all other auxiliary cables and accessories. Install the radio into the
mounting bracket and connect all cables and accessories to the appropriate jacks and
connectors.
REAR PANEL CONNECTORS
1. EXTERNAL SPEAKER CONNECTOR -lf it is desired to use a speaker other than
the one in the radio, a four or eight ohm speaker equipped with a miniature phone
plug may be connected to this jack. The internal speaker is disabled when an
external speaker is used,
2. INTERCOM CONNECTOR-When using the intercom feature, a four or eight ohm
speaker with a miniature phone plug should be connected to this jack. Refer to the
section for intercom operation.
- 3 -