Cobra Electronics MICROTALK CXR725C - Manual (Page 4)

3 2
For charging microTALK radio(s) in desktop
charger:
1. Insert radio(s) into desktop charger as
shown.
2. Insert round connector of 120-volt adapter
into jack on back of charger.
3. Plug 120-volt adapter into electrical outlet.
If charging light is not on, check position of radio. Radio should
be upright. The charge indicator light will stay on as long as the
radio is in the charging well.
It normally takes about 15 hours to fully recharge battery pack.
Battery pack will not be damaged if it stays in the charging well
longer than that.
Note: To charge a single radio, you can bypass the desktop
charger and simply insert the wall adapter’s round connector
directly into the speaker/microphone/charge jack located on the
top of the radio.
Use only the supplied rechargeable batteries and charger for
recharging your Cobra microTALK radio.
Cobra recommends your radio is turned off while being charged.
Turning on Your microTALK Radio
•
Press and hold the Power button until you
hear a series of audible tones indicating the
radio is on.
Your microTALK radio is now in Standby mode,
ready to receive transmissions. The radio is
always in Standby mode, except when the
Talk, Call or Power buttons are pressed.
Battery Low
•
When battery power is low, the Battery Low icon
will blink. Your batteries should be recharged
Auto Battery Save
•
Your microTALK radio has a unique circuit
designed to extend battery life. If there are
no transmissions for 10 seconds, the radio will
automatically switch to Battery Save mode and
the Power Saver icon will flash in the display.
This will not affect the radio’s ability to receive
incoming transmissions.
Communicating with Another Person
•
1. Press and hold the Talk button.
2. With the microphone about 2 inches
(5 cm) from your mouth, speak in a
normal voice.
3. Release the Talk button when you are
finished talking and listen for a response.
You cannot receive incoming calls while
pressing the Talk button.
Both radios must be tuned to the same
channel/privacy code to communicate.
Introduction
Using Your Radio
Customer Assistance Warranty Introduction Operation
On/OffPower
BatteryLow
BatterySaveMode
TalkButton
InsertRadio(s)
Quick Start
1. Press and hold the Power button to turn
on your radio.
2. Press the Channel Up or Channel Down
button to select a channel.
Both radios must be tuned to the same
channel/privacy code to communicate.
3. Press and hold the Talk button while
speaking into the microphone.
4. When finished talking, release the Talk
button and listen for a response.
2Inches(5cm)from
Mouth
Nothing Comes Close to a Cobra ®
CXR725C_MANL_ENG.indd2-3 12/15/092:10PM