Cobra Electronics XRS 9300 - Manual (Page 10)

Detection
Your Detector
Nothing comes close to a Cobra ® 13
Detection
•
Signals Detected
The tables on the following pages show you the types of Signals your
detector will detect, as well as the visual alerts it provides for each of them.
Audio Alerts
A distinctly different Alert tone is used for each type of signal detected
(including separate tones for each laser signal). For X, K and Ka band
radar signals, the tones will repeat faster as you approach the signal
source. The repeat rate of the tones gives you useful information about
the signal detected. (See responding to alerts on page 16.)
Visual Display
An indication of the type of signal detected will appear in the UltraBright
data Display. During X, K and Ka alerts, a number will also appear,
indicating the strength of the signal detected. (1 = weakest, 5 = strongest)
During laser alerts the letter L will appear, instead of the signal strength indication.
During VG-2 or Spectre 1 alerts, the letter V will appear. It will be steady
during VG-2 and blink during Spectre 1.
During Safety Alert and Strobe Alert the letter S will appear. It will be
steady during a Safety Alert and will blink during a Strobe Alert.
Settings
Your Detector
12 English
VG-2 And Spectre 1 Alert Audio Settings
The detector is undetectable by police VG-2 and Spectre 1 radar detector
detectors and will alert you when such a device is in use near your vehicle.
During the alert, the unit continues to detect other signals. You can choose
whether or not you want your unit to show VG-2 and Spectre 1 alerts.
The factory setting is VG-2 and Spectre 1 alert On.
Dim Button
Press and hold for
two (2) seconds
On/Off Indicator
X K Ka V S c
X Signal Detected
X K Ka V S
2
Laser Signal Detected
X K Ka V S
L
VG-2 Alert Signal Detected
X K Ka V S c
K Signal Detected
X K Ka V S
3
Ka Signal Detected
X K Ka V S
5
Safety Alert Signal Detected
X K Ka V S c
Strobe Alert Signal Detected
X K Ka V S c
Spectre 1 Alert Signal Detected
X K Ka V S c
To Turn VG-2 And Spectre 1 Alerts Off
While no signal
is being detected,
press and hold
the Dim button for
two (2) seconds. Tone Visual Display
One (1) beep V will blink once
in the display
To Turn VG-2 And Spectre 1 Alerts On
While no signal
is being detected,
press and hold
the Dim button
for two (2)
seconds again. Tone Visual Display
Two (2) beeps V will blink twice
in the display