Sharp R-9H84B - Manual (Page 6)

UNPACKING AND INSTALLATION INSTRUCTIONS
Unpacking and Examining Your Oven
Remove:
1, ail packing materiaisfrom inside the oven cavity. Read enclosures and
SAVE the Operation Manual.
2. the feature sticker from the outside of the door, if there is one.
Check the oven for any damage, such as misaligned or bent door,
damaged door seals and sealing surfaces, broken or loose door hinges
and latches and dents inside the cavity or on the door. If there is any
damage, do not operate the oven and contact your dealer or SHARP
AUTHORIZED SERVICER.
Choosing a Location for Your Oven
You will use your oven frequently so plan its location for ease of use. The
oven mustbe placed on a countertop which isa minimum of 36 inchesfrom
the floor. Allow at least 2 inches on the sides, top and at the rear of the oven
for air circulation. Be sure to position oven so that the rear cannot be
touched inadvertently
R-9H84B/-9H04B
Do not place or install the oven in any area where heat and steam are
generated: for example, next to or above a conventional gas or electric
range or above any wall oven Heat and steam may damage the electronics
or the mechanical parts of the oven.
Your oven can be built into a cabinet or wall - not near or above a heat
source-using Sharp's Built-in Kit, Model RK-90W for the R-9H94B oven
and Model RK-90 for the R-9H84B oven,
R-9H66/-9H76
Your oven can be built into a cabinet or wall by itself or above applicable
General Electric brand wall ovens using Sharp’s Built-in Kits RK-66A for
R-9H76 or RK-66W for R-9H66. It cannot be built in above conventional
gas or electric ranges or any other wall ovens.
AoDllcable General Electric brand wall ovens
ZEK734GP ZEK735WP
See Sketch 1 for proper location when building in above the specified G,E
wall ovens. Carefully follow both the G.E. wall oven installation instructions
and Sharp's Built-in Kit instructions. Be sure that the clearance of the floor
between the wall oven and the microwave oven is min. 1-Va inches ,
R-9H66 or R-9H76
GE electric
oven
Sketch-1
Ordering the Built-in Kits.
If your dealer does not stock the kit, it can be ordered directly from the Sharp Accessories and Supplies Center. Have your credit
card number available and call toll-free: 1-800-BE-SHARP for ordering the kit ot be sent to your address.
The kit includes ducts and finish trim strips and easy-to-follow instructions for instailation as well as the location of the power
supply