Craftsman 137.21602 - Manual (Page 26)

26 27 26 27
OVERLOAD BREAKER (FIG. U)
When the motor in overload during
operation, the overload breaker will
cause the motor to stop automatically
to prevent damage to the motor. Push
in the ON/OFF switch (2) to turn saw
OFF, after that push the ON/OFF
switch (2) to ON to start the saw.
Other way to restart the saw:
Disconnect the power supply firstly,
keep switch in ON position, then
connect the power supply, the motor
will start automatically.
Fig. U
RECOMMENDATIONS FOR CUTTING
1. When feeding the workpiece into
the blade do not force the leading
edge of the workpiece into the
blade because the blade will
deflect, reducing the accuracy
of cut and possibly breaking the
blade. Allow the saw to cut material
by guiding the workpiece into the
blade as it cuts.
2. The blade teeth cut material ONLY
on the down stroke.
3. You must guide the wood into the
blade slowly because the teeth of
the blade are very small and they
VARIABLE SPEED CONTROL AND
ON/OFF SWITCH
● For your own safety, always push
the switch “OFF” when the scroll
saw is not in use. Also, in the
case of power failure (all of your
lights go out) push the knob
“OFF”. Remove the plug from
the power source outlet to avoid
accidental starting.
● The variable speed control allows
greater versatility to cut a variety
of materials such as wood,
plastics, non-ferrous metals, etc.
Depending on the hardness and
thickness of material, the speed
should be reduced to allow
the blade teeth to remove cut
material from the kerf.
VARIABLE SPEED SWITCH (FIG. U)
1. Your saw is equipped with a
variable speed control knob (1).
The blade stroke rate may be
adjusted by simply rotating the
variable speed control knob (1).
2. Turn the control knob clockwise
the increase up to 1,600 strokes
per minute (SPM). Turn the control
knob counterclockwise to reduce,
down to 400 strokes per minute
(SPM).
ON/OFF SWITCH (FIG. U)
1. To turn power ON or OFF, push the
ON/OFF switch (2).
1
2
OPERATION

WARNING !