Kenmore 100.81002 - Manual (Page 6)

OPERATINGíYOüR FOOD PROCESSOR
CONTROLS
When Ihe processor is piugged In, lha greBn Power light iliuminates to show that the unit
is connected to a power source. When the base, bowl and cover assembly is eorreclty
connactad and locked into place, tha OFF tight is also illuminated green to show that the
unit is ready to operate If the OFF light is not green, the bowl and cover are not locked
together oorrectiy,-
PULSE: When the Control Knob Switch is lurned counterclockwise lo PULSE and held, !ha
green PULSE light comes on and the Food Processor operates As soon as you 1st go of the
Switch the Processor shuts off and the Switch returns the OFF position. Use PULSE lor
short processing tasks, such as chopping nuts, raw meats or vegetables. This allows you
much greater control of the consistency of what you are processing.
ON: When the Control Knob Switch is turned clockwise to ON, the green ON tight comes on
and the urrit will run continuously This Is good for less fender food and ilems that lake a while
longer 10 process When you have finished processing, turn the control knob switch to OFF,
CHOPPING;
1 lock the Bowl onto the Base as described tn Assembly
2 Placa the Chopping Blade onto the Center Post
( ebb Fig,, 4)
CAUTION: Blades are sharp. Handle Carefuiiy,
3 Place food to be dropped into Bowi Refer to Food Guide to
prepare food (or chopping
4 Lock Bowi Cover Assembiy onto Bowl, as described in
Assembly
5 Lock the Food Pusher into the Movable Loop by rotating
counterclockwise uttlil the food pusher’s lab is under slot
in the movable loop's IW, then lock food chute iid into the
spring operated Elide button by pressing down firmly,
6 The Food Processor should ba in the OFF ijosttton, Plug the
cord into an electric outlet. The Power light iuminales preen to show it is connected (o
a power source, and the OFF button llluminatas green if base, bowl, arrd cover assembly
are all locked inlo place
7 Turn the knob to ON to run corrstantly, or for better control
over conslstertcy, turn and hold knob on PULSE,
8 Whetr finished processing;
• if Pulsing, releasB Knob Switch and unit automatically stops.
• if you turned processor to ON, turn Corttrol Knob Switch lo OFF to slop
• Allow the chopping biade lo stop rotating