Troubleshooting – Kenmore 580.54701 User Manual
Page 15
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Maintenance
TROUBLESHOOTING
The dehumidifier may be operating abnormally when:
What To
Dehumidifier
does not start
■ The fuse is blown or circu
breaker is tripped.
■ Water bucket is full.
ii Bucket t$ boi installed.
humidity is less than
selected humidity setting.
• Make sure the dehumidifier piug is pushed
completely into the outlet.
• Check the house fuse or circuit breaker box
and replace the fuse or reset the breaker.
• The dehumidifier automatically turns off
when this occurs. Empty the bucket.
• Make sure the bucket is in the right place.
• Press the humidity control button to
lower the humidity.
Dehumidifier
does not dry the
air as it should
■ Did not allow enough time
to remove the moisture:,
■ Airflowis restricted.
• When first installed, allow at least 3 or 4
days to maintain the desired dryness.
• Make sure there are no curtains, blinds or
furniture blocking the front or back of the
dehumidifier.
• Press the®Humidity Control button to
lower the humidity.
• Check that all doors, windows and other
openings are securely closed.
• Install the dehumidifier away from the dryer.
The dryer should be vented to the outside.
• The 50 pint model(54501 ) may not operate efficiently
if the room temperature is below 65°F(18°C).
• The 70 pint Low Temperature model(54701} wili
continuously cycle up to the temperature 42°F (6°C).
Dehumidifier
runs
too much
■ Area to be dehumidified is.
too large.
■ Doore and o^fi.
• Check with your dealer to see if the capacity
is adequate.
■ Close all doors and windows to the outside.
Frost appears on
■ Dehumidifier t^Ì|ently
• This is normal. Frost will usually disappear
the coils
temperaluhdf$ below OT
iim).
within 60 minutes.
Fan noise
ddhurntdler. ■■
• This is normal.
Water on floor
: is not tn ■
* Check the hose if one is attached.
• See Removing and Emptying the Water
Budget.
Dehumidifier
i Check.tftbMÌÉfe'
• Change the humidity setting, to 35% or
operates
■ 'mode.
above.
continuously
*RooinNt»nldìtyìs high
• Change the humidity to lower setting.
Owner’s Manual 15